Sony SAT-A1 - Manual (Page 83)

Precautions
On Safety
□
□
If you spill or drop anything into the cabinet, unplug the receiver
and have it checked by qualified personnel before operating it any
further.
Operate the receiver only on 120 V AC.
For detailed safety precautions, see the "Important Safeguards"
leaflet that came with the receiver.
On Power Sources □ The receiver continues to draw power from the AC power source
as long as it is connected to the wall outlet, even if the receiver
itself has been turned off.
□ If you are not going to use the receiver for a long time, be sure to
disconnect the receiver from the wall outlet. To disconnect the AC
power cord, grasp the plug itself; never pull the cord.
□ One blade of the plug is wider than the other for the purpose of
safety and will fit into the wall outlet only one way. If you are
unable to insert the plug fully into the outlet, contact your dealer.
□ If the AC power cord gets damaged and needs to be replaced, have
it done at a qualified service shop only.
On Placement
On Cleaning
□ Place the receiver in a location with adequate ventilation to prevent
heat build-up in the receiver and prolong the life of the receiver.
□ Do not place the receiver in a location where it will be exposed to
extreme hot or cold temperatures. Avoid direct sunlight and do not
place near heat sources.
□ Do not place the receiver in a location subject to excessive dust or
mechanical vibration. Protect from vibration at all times.
□ Do not place anything on top of the receiver, which might block the
ventilation holes and cause malfunctions.
□ Before connecting other components, be sure to turn off and
unplug the receiver.
□ Clean the cabinet, panel, and controls with a soft cloth slightly
moistened with a mild detergent solution. Do not use any type of
abrasive pad, scouring powder, or solvenf such as alcohol or
benzine.
On Repacking □ Keep the original cartons and packing materials to safely transport
the equipment in the future.
86 Appendix: Other Information