Sony SAT-A1 User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To Determine the Current
Security Code for the DSS
Remote Control
Step 2; Set the DSS Remote Control's RF Security Code
1
2
Press the CODE SET button on the DSS remote control.
Using the number buttons on the DSS remote control, enter the
three-digit security code you selected for the DSS receiver in step 3
on page 70.
3
Press the ENTER button on the remote control.
The RF security code is now changed for both the DSS receiver and
remote control.
You can determine the current RF security code for the DSS remote
control using the IDENTIFY button in the Set Up remote screen.
1
Bring up the Setup Remote screen, as described on page 69.
2
Select IDENTIFY.
SET UP REMOTE
REMOTE SIGNAL
RF SECURITY CODE
RF ONLY
009
OK
CANCEL
IDENTIFY
HELP
Press the joystick within 5 seconds.
3
When the message "Press the joystick within 5 seconds" appears,
press the joystick before the 5 seconds expire.
The current RF security code for the DSS remote control appears.
SET UP REMOTE
OK
REMOTE SIGNAL
RF ONLY
j
CANCEL
RF SECURITY CODE 009
IDENTIFY
HELP
Your remote is currently set at 000.
Note
If the message, "Security code could not be identified" appears, check to make
sure that RF is enabled. See "Selecting IR/RF Transmission" on page 69.
4
Select OK to return to the Installation Menu.
Chapter 6: Using the Installation Menu 71
I