Running a system test, To run the system test – Sony SAT-A1 User Manual
Page 69
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Running a System Test
The System Test lets you check the integrity of your system's
components, including;
□
Antenna signal
□
System tuning
□
Phone line
□
Access card
Use the System Test if you are experiencing problems with your
system.
To run the System Test:
1
Select RUN SYSTEM TEST from the Installation Menu.
2
Select TEST.
RUN SYSTEM TEST
SIGNAL
TUNING
PHONE
CARD
RETURN
HELP
If The System Test Reports
Any Problems...
The System Test checks all the components automatically, and
displays the result of each test.
3
Select RETURN to return to the Installation Menu.
Check your system for any of the following;
□
The access card test will fail if you have not yet called your
program providers to establish service. After your service has been
established, the access card test should pass.
□
Check that all cables are connected properly to the DSS receiver.
□
Check that the satellite antenna is installed correctly, and that the
signal has been optimized. See the manual that came with the
satellite antenna for details.
□
Check that the phone line connected to the DSS receiver is working
properly.
□
Check that the access card is inserted properly.
If you cannot resolve problems reported by the System Test, see
"Customer Support" on page 2.
72 Chapter 6: Using the Installation Menu