Nikon LS-10 Installation Guide for Macintosh - Manual (Page 15)

Setting Up Coolsian Chapter 2
The focus wheel must be in its center position during power up. The center posi­
tion is indicated by the black line across the focus wheel being centered in the visible
portion of the focus wheel.
Power/Busy/Error Indicator Light
The green
power/busykrror indicator light
has several functions. First, during
power-up it blinks at one-second intervals until Coolscan’s power-on self-test and autoc­
alibration has completed. Second, after the self-test and autocalibration is complete, the
light stays on constantly, indicating that Coolscan is ready to scan. Third, during scan­
ning, the light will blink at two-second intervals, indicating that the scanning operation
is in progress. Lastly, the light will blink rapidly if an error is detected, in which case the
scanner will either recover on its own, or may have to be powered off and back on to
effect a reset.
To summarize;
Power-up: LED blinks at 1 second intervals
Coolscan is ready: LED is on constantly
Coolscan is scanning: LED blinks at 2 second intervals
Error condition: LED blinks rapidly
If you are installing an LS-10 model, please proceed to the section “The Rear
Panel - LS-10.”
The Rear Panel - LS-10E
The rear panel of the LS-lOE is shown in Figure 2.2. Note that there are five
items of interest on the rear panel. These are the
AC power switch, AC power connector,
the two
SCSI connectors,
the
SCSI termination power switch,
and the
SCSI ID switch.
Page 8
Nikon
Coolscan Installation Guide for Macintosh