Nikon LS-10 Installation Guide for Macintosh User Manual
Page 29
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
The SCSI Interface
Chapter 3
If Coolscan is to be connected in the middle of the SCSI chain: Connect one
end of this cable to the existing SCSI bus (connecting the SCSI cable to the Macintosh’s
SCSI bus will be explained in the next section), connect the center connector to the
SCSI connector on the rear of Coolscan, and connect the last connector to your internal
disk drive.
(b) Non-chainable SCSI
Flat Cable (not provided)
SCSI 50-Pin Connectors
Connector Protection Key
Figure 3.6
SCSI flat cables, (a) Chainable SCSI flat cable provided with Coolscan.
(b) Non-chainable SCSI flat cable.
The cable seen in Figure 3.6b is a
non-chainable SCSIflat cable.
If you already
have one of these, it can be used instead of the supplied cable if you are installing
Coolscan as the last device in the SCSI chain.
E
Make sure that DIP switch #4 is in the termination OFF position, as indicated in
Figure 3.4.
SCSI cables should never be connected or disconnected while the computer’s or
SCSI device’s power is on. Such action can damage the SCSI controller chip on
your Macintosh, requiring a motherboard replacement.
Please proceed to the section “The Macintosh’s Internal SCSI Connector.”
Page 22
Nikon
Coolscan Installation Guide for Macintosh