Positioning the film in the holder – Nikon LS-10 Installation Guide for Macintosh User Manual
Page 51
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Basic Operation
Chapter 4
Figure 4.12
The film strip holder with film inserted, ready for scanning.
When open, as shown in Figure 4.13, film can be placed in the holder by posi
tioning the desired frame so that it aligns with the holder's open window. Only one
frame of the film strip can be scanned at a time. To scan additional frames, the film
must be moved to the appropriate position in the film strip holder.
Figure 4.13
The open film strip holder.
Page 44
Positioning the Film in the Holder
There is one window on the film strip holder, as shown in Figure 4.11. This win
dow will contain the only portion of the film that will be visible to Coolscan during
scanning operation. Therefore, it is necessary to align the frame you wish to scan within
this window when positioning the film in the holder.
In order to scan every frame, film strips should be limited to six frames in length
because of the length of the holder. No film can extend out of the front of the film strip
holder (the end which is inserted into Coolscan), and no more than two frames can
reside in front of the desired frame for scanning.
Nikon
Coolscan Installation Guide for Macintosh