Carrier Access Access Navigator - Manual (Page 380)

15-38 August 2003 Access Navigator - Release 1.8
Diagnostics & Troubleshooting
Send Remote RS232 TSI Network Loopup
Send Remote RS232 TSI Network Loopup
This command makes the remote Access Bank II perform a network loopback on the RS-232 data. This
takes the received RS-232 DS0 from the network T1, loops it in the Time Slot Interchange (TSI), and
sends it back to the T1 output. See Figure 15-13.
Syntax: send remote 9 rs232 tsi network loopup
Figure 15-13. Remote RS-232 TSI Network Loopup
Send Remote SDSL Payload Loopup
This command makes the remote Access Bank II/SDSL perform a payload loopback on the SDSL data
from both network and equipment sides. On the network side, this takes the received SDSL DS0s from
the T1, loops it in the SDSL interface, and sends them back through the Time Slot Interchange (TSI) to
the T1 output. On the equipment side, this takes the received data from the SDSL equipment, loops it
in the SDSL interface, and sends it back to the SDSL output. See Figure 15-14.
Syntax: send remote <n> sdsl payload loopup
Figure 15-14. Remote SDSL Payload Loopup
RS-232
TSI Network Loopup
RS-232 DS1
Access
Navigator
CA FDL
Command
Access Bank II
T1 Interface
Time Slot
Interchange
Framer
SDSL
Payload Loopup
SDSL DS1
Access
Navigator
CA FDL
Command
Access Bank II
T1 Interface
Time Slot
Interchange
Framer