Carrier Access Access Navigator - Manual (Page 607)

Access Navigator - Release 1.8 August 2003 18-151
CLI Language Reference
CLI Command List
Show Remote Connections
Purpose: Displays crossconnections between interfaces inside the remote Access Bank II,
including the T1 connection to the Access Navigator DS1.
NOTE: The show remote commands display the settings stored in the
Access Navigator’s data base, while the read remote commands show the
actual settings of the remote device. Both commands should display the same
settings when remote configuration is enabled so the Access Navigator can
provision the remote Access Bank II. Set Remote Config on
page 18-119
Security: Level 3 (monitor)
Syntax: show remote <n> connections
Example: show remote 9 connections
This command produces a message similar to the following. The message shows static
connections between each span and channel as a table, where the span is the interface
and the channel is the DS0.
Line Build Out DSX-1 equalization (ft.), CSU attenuation (dB)
PRM Performance messages: AT&T 54016, ANSI T1.1403
V.35 Port:
CTS Always High, Always Low, Follow CD, Follow RTS
Rx Timing Internal, External
Clock Inversion None, Rx, Tx, Rx and Tx
Data Inversion None, Invert
Speed Data speed (Kbps): Nx56 or Nx64, where N is number of DS0s
assigned
DSU V.54 Data Service Unit (DSU) loopcode detection: On, Off
RS232 Port:
Baud Rate 1200, 2400, 4800, 9600, 19200, 38400, 57600
Data Bits 7, 8
Parity None, Odd, Even
Stop Bits 1, 2
Field Description
n DS1 number, 1 to 32.
Item Description