Canon AUTO ZOOM 1014 - Manual (Page 19)

0 Checking the Batteries
^ If there is not enough voltage the camera does not work properly. It is
advisable to check the batteries occasionally.
• Turn the switch dial to "R", push the battery check button and read the
needle in the check window.
• When the needle points to the blue zone, the voltage is satisfactory and
you can use any shooting technique. When the needle is in the white zone,
the voltage is enough only to run the film at 18 fps. When the needle is in
the red zone, the voltage is too low and you should change the batteries.
With the needle in the red zone, even if the camera seems to work, the
voltage is not enough to operate the exposure system properly, so be sure
to change the batteries.
к Eyepiece Adjustment
' Look into the viewfinder while directing the camera to a bright
subject. Loosen the tightening screw and rotate the eyepiece adjustment
ring till you can see the lines of the split image screen clearly in the center
of the viewfinder. Then, close the tightening screw.
• Without adjusting the eyepiece to your individual eyesight, you cannot
focus correctly.
• The microprism rangefinder can be interchanged at the Canon Slation
written on the iast page of this instruction booklet and the only charge will
be its actual cost.