Canon AUTO ZOOM 1014 - Manual (Page 56)

turn the switch dial of the camera to "R" or "OFF" beforehand, otherwise
the camera starts operating when you remove the remote control switch
and you will waste film.
• When the remote control switch is out of use, be sure to set the switch
dial at "OFF" to prevent the batteries from being wasted. So be sure to
make preparations just before the actual operation.
• Check the conditions of the subject carefully before you operate the
camera from a distance.
• If the eye is not against the eyepiece, be sure to close the eyepiece
shutter.
0 Single-Frame Shooting
The Canon Auto Zoom 1014 Electronic has a magnetic shutter release
mechanism, and can perform perfect EE shooting including single-frame
shooting with the combined use of remote control switch.
• Single-frame shooting can be performed as follows:
Set the filming speed dial at "1", connect the Remote Control Switch 60
or 3 to the remote control socket of the camera, turn the switch dial to
"RL". and press down the button of the remote control switch
• If the switch dial is not set at "RL", correct exposure cannot be
obtained.
4 Self-Timer E
By inserting the Self-Timer E in the remote control socket, u n m a n n e a
photography can be performed, while maintaining the camera in r u n n i n g
(RL) condition. You can join the scene you shoot. Shooting begins t e n
seconds after you press the start button in the center of the timer, a n d it
lasts ten seconds.
5 Interval Timer E
This electronic timer is used to shoot single frames at fixed intervals
inserted in the remote control socket after switching the dial to '’RL '. The
interval time is controlled from one second up to 60 seconds by the dial
in the center of the timer.
The Interval Timer E will synchronize the electronic flash.