Canon AUTO ZOOM 1014 - Manual (Page 50)

If the lamp does not blink in this case, you Know that there was some
trouble during fading out or rewinding.
If the lamp stops blinking in ordinary shooting, push the rewind
mechanism cancellation button and then siaa shooting again.
In lap dissolve or in superimposition, if the lamp does not blink after
rewinding the film, remove the cartridge and advance the film about
10cm (4') by turning the axis of the canridge manually.
If, nevertheless, the film does not advance, change the cartridge.
• After removing the cartridge, keep pulling the trigger until the rewind
switch button switches to show the orange mark.
Then you can reset lap dissolve immediately.
orange blue
0
Superimposition (
1 I ISSSI)
When fade-in and fade-out are excluded from lap dissolve, it is called
superimposition. Usually, this serves for shooting titles.
• First unlock the variable shutter control lock by sliding the fading setting
button to the right and set it to the blue mark. Next move the film rewind
switch button to the left to point to the blue mark.
If the variable shutter control lock is not released, the film rewind switch
button will not move to the left, but this is not a breakdown.
• Set the variable shutter control ring to "2" and lock the ring by sliding
the fading setting button to the left.
• Continue to pull the trigger until the film stops automatically. When the
film stops running, unlock the variable shutter control ring. Turn the ring
and match the index to the "REWIND" position and rewind the film
completely.
• Return the variable shutter control ring to the scale "2". and lock it
Continue to shoot. When you finisn supenmcosition, you hear a "click'
Then return the variable shutter control ring to "O" (OPEN) and lock it.
• When titling, first shoot the desired scenes with proper exposure, anc
then shoot the titles written on a black background.