Canon AUTO ZOOM 1014 - Manual (Page 54)

Variable Use of the Shutter
. Running Lock
I The running lock is for continuous shooting. Set the switch dial at
"RL" and pull the trigger. The shutter is locked at the rurining position
and the film keeps running even if you remove your hand from the trigger.
When releasing the lock, return the switch dial to "R".
„ Remote Control
^ Remote control EE shooting is possible with the combined use of the
Remote Control Switch 60 or the optional Remote Control Switch 3, and
it is convenient when you set the camera far from you. The Remote
Control Switch 60 has a cord of 60 cm (2 ft) for general shooting or to
avoid blur in single frame shooting. The cord of the Remote Control
Switch 3 is 8 meters (26 ft) long.
The optional Extension Cord E1000 may be used between the camera and
the Remote Control Switch. Considerable numbers of the Extension Cord
El000 may be connected, and so it is convenient to shoot from long
distance.
CONNECTING THE REMOTE CONTROL SWITCH
Set the switch dial of the camera at ''OFF" and remove the cover of the
remote control socket to connect the plug of the remote control switch.
Then set the switch dial at "RL" and pull the trigger as with the running
lock. You can set the switch dial while pulling the trigger.
OPERATION
When you push down the switch of the remote control switch, the film
starts running, and when you slide it following the arrow while pressing it,
the switch is set as a running lock.
When you use a remote control switch in manual aperture control
operations, read out the proper f/stop number in the viewfinder and set the
aperture by pulling out the EE/manual aperture control ring and rotating
it.
REMOVING THE REMOTE CONTROL SWITCH
When you remove the remote control switch from the camera, be sure to