Catler ES 8012 - Manual (Page 37)

37 37
CARE AND CLEANING
CLEANING CYCLE PROCESS GUIDE
If cleaning is required, simply follow the steps
below and refer to the Machine Cleaning Cycle
Guide.
1. Use granulated citric acid.
2. Place the fi lter basket into the portafi lter.
3. Pop 1 teaspoon of granulated citric acid into
the fi lter.
4. Lock the portafi lter into the group head.
5. Turn the machine ‘OFF’.
6. Simultaneously press and hold the one cup,
two cup and the POWER button for 3 seconds.
7. The cleaning cycle will commence and last
for approximately 5 minutes. Once com-
plete, 3 beeps will sound. Remove the por-
tafi lter and ensure teaspoon of granulated
citric acid has completely dissolved.
If the granulated citric acid has not dissolved, re-
peat steps 5 to 7 until tablet has dissolved.
NOTE:
Before the beginning of the cleaning
process ensure the drip tray is empty.
After the finishing the cleaning process
empty the drip tray.
DECALCIFYING
After regular use, hard water can cause mineral
build up in and on many of the inner functioning
components, reducing the brewing fl ow, power
of the machine, and aff ecting the quality of cof-
fee.
We advise decalcifying the machine on a regu-
lar basis (every 2-3 months) using a mixture of
white vinegar and water.
Follow the instructions provided, or use the fol-
lowing as a guide:
Diluted solution (for softer water)
•
1 part white vinegar
• 2 parts cold tap water
Concentrated solution (for harder water)
•
1 part white vinegar
• 1 part cold tap water
DECALCIFYING THE MACHINE
• Remove the portafi lter and frothing attach-
ment. Pour the mixture of white vinegar and
water into the water tank.
• Plug the machine into the power outlet and
switch on.
• Press the POWER button to the ‘On’ position.
• Place a large container under the group
head and steam wand.
• When the brewing temperature has been
reached all the button surrounds on the
Control Panel will illuminate. Press and hold
the one cup
or two cup button to
commence manual pour. Release the button
once half the mixture of white vinegar and
water has run through the group head.
• Set the steam dial to the ‘STEAM’ position
and allow steam to run through the Steam
Wand for approximately 2 minutes. Return
the steam dial back to the ‘OFF’ position.
• After decalcifying, remove the water tank
and rinse thoroughly then refi ll with fresh
cold water. To rinse the machine, repeat pre-
vious steps.
WARNING: DO NOT IMMERSE POWER CORD,
POWER PLUG OR APPLIANCE IN WATER OR
ANY OTHER LIQUID.
THE WATER TANK SHOULD NEVER BE RE-
MOVED OR COMPLETELY EMPTIED DURING
DECALCIFYING.