Installing the dyno shaft coupler, Installing the dyno shaft coupler -11, Figure 1-14: replace the coupler set screws – Dynojet 150: Eddy Current Brake User Manual
Page 17: Figure 1-15: install the dyno shaft coupler
Advertising
E D D Y C U R R E N T B R A K E I N S T A L L A T I O N
Eddy Current Brake
Version 8
Eddy Current Brake Installation Guide
1-11
I
NSTALLING
THE
D
YNO
S
HAFT
C
OUPLER
1
Replace the existing set screw in the key way of each coupler with the thread-lock
set screws provided.
Note: Replace the dyno shaft coupler set screw before installing the coupler on
the shaft.
Figure 1-14: Replace the Coupler Set Screws
2
Insert the key into the keyway.
3
Slide the coupler over the key on the axle.
Note: Do not tighten the set screw in the coupler.
Figure 1-15: Install the Dyno Shaft Coupler
dyno shaft coupler
key way
key way
eddy current brake coupler
set screw
set screw
coupler
key way
Advertising
This manual is related to the following products: