Dynojet 150: Eddy Current Brake - Manual (Page 18)

Eddy Current Brake Installation Guide
C H A P T E R 1
Eddy Current Brake
1-12
C ONNECTING THE E DDY C URRENT B RAKE
The following instructions and figures show the eddy current brake mounting to the
left side of the dyno; however, the instructions are the same for both left and right
side installations.
Use the following instructions to install the eddy current brake to both the standard
and high inertia drums. If you have a high inertia drum, refer to Appendix B for
installation details.
1
If not already removed, remove the bolts and washers from the dyno frame as
shown in Figure 1-16.
Figure 1-16: Remove the Connecting Bolts from the Dyno
2 Place the eddy current brake next to the dyno.
3 Line up the connecting arms with the dyno and loosely attach the arms to the
dyno using four 3/8-inch bolts and 3/8-inch washers for each arm. These bolts
need to remain loose in order to align the brake
Note: If you have an older dyno with no threaded insert, you will also need to use
3/8-inch nuts with threadlock on the inside of the dyno side panel.
Figure 1-17: Connect the Eddy Current Brake
remove
do not remove
remove