Dynojet 150: Eddy Current Brake - Manual (Page 26)

Eddy Current Brake Installation Guide
C H A P T E R 1
Theta Controller
1-20
I NSTALLING THE T HETA C ONTROLLER —L EFT S IDE
The Theta Controller is mounted on the left side of the dyno regardless of which side
the eddy current brake is on. The only exception is when the air brake is mounted on
the left side and the eddy current brake is mounted on the right side. Refer to
“Installing the Theta Controller—Right Side” on page 1-22 for more information.
Be sure to set the dip switch power settings before installation.
1
Attach the input power cable to the Theta Controller as shown in Figure 1-27.
2 Place the large rubber grommet over the plug on the eddy current brake power
cable.
3 Route the brake power cable through the dyno as shown in Figure 1-27 and attach
the cable to the Theta Controller. Secure the rubber grommet in the hole.
4 Secure the Theta Controller to the dyno using four No. 8 screws and lock
washers.
Figure 1-26: Theta Controller—Install on Left Side