Dynojet 150: Eddy Current Brake - Manual (Page 24)

Eddy Current Brake Installation Guide
C H A P T E R 1
Theta Controller
1-18
D RILLING THE M OUNTING H OLES
Depending on the age of your dyno, you may need to drill the holes needed to mount
the Theta Controller. If your dyno already has the required holes, skip these steps and
continue with the installation.
L EFT S IDE I NSTALLATION
1 Locate the template for left side installations included with the control box.
This template can also be found in Appendix D.
2 Locate the large hole on the left side of the dyno. This hole should have four
smaller holes around it.
3 Place the template on the dyno. Line the template up using the large hole and the
four smaller holes around it.
4 Mark and drill the four mounting holes to 3/16-inch (5 mm).
Note: Make sure no metal chips come in contact with the electrical components.
Figure 1-24: Theta Controller—Drill Mounting Holes on Left Side
large hole
template