Dynojet 150: Eddy Current Brake - Manual (Page 8)

Eddy Current Brake Installation Guide
C H A P T E R 1
Parts List
1-2
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PARTS LIST
The following table lists all of the parts included in the Eddy Current Brake
Installation kit. Check your kit against the parts listed to make sure you have received
all of the parts. If any part is missing, contact Dynojet Technical Support.
part number description quantity
197104130 4" Zip Tie 4
25111310 Clamp, Retarder Hood 2
61229101 Hood Assembly, M/C Retarder 1
62992001
Or
62992002 Retarder-Generic
Or
Retarder-Generic, European 1
29250001 Mod-Key, 1/2 x 7/16 x 2" 1
29250002 Key, 3/8 x 3/8 x 2" (installed) 1
32431332 Male Coupler, mounted on eddy current brake
(with male coupler hub, P/N 32431330, installed)
1
32431333 Female Coupler Assembly with four set screws
(with female coupler hub, P/N 32431331, installed)
1
36488101 Nut, 3/8-16, Hex, W/Tlok 5
36581270 Bolt, 3/8-16 x 3/4", W/Tlok 28
36581670 Bolt, 3/8-16 x 1", W/Tlok (for right side installation) 4
43312200 Grommet, 1-5/8OD x 1-3/8ID (one is installed) 2
61329105 Connecting Rod Sub-Assembly 2
66411002
Or
66411003 Theta-2 Controller-120V
Or
Theta-2 Controller-240V 1
66952004 Power Cable, M/C Retarder Sub-Assembly 1
DC100-104 Pendant and Cable 1
DM150-002-007 5/16" Flat Washer 8
DM150-033 Rubber Grommet 1
Red Head Anchor Kit 1
Theta Controller Mounting Hole Drill Template For Left Side Mounting 1
Theta Controller Mounting Hole Drill Template For Right Side Mounting 1
The following part number should be used when replacing all of the coupler pieces:
78122002 Coupler Kit