Replacing the fuse, Replacing the fuse -24, Figure 1-32: theta controller—replace the fuse – Dynojet 150: Eddy Current Brake User Manual
Page 30
Eddy Current Brake Installation Guide
C H A P T E R 1
Theta Controller
1-24
R
EPLACING
THE
F
USE
Older Theta Controllers have an internal fuse. Refer to Appendix C for more
information on replacing an internal fuse.
Hazardous voltage. To avoid risk of electrical shock, disconnect the power cord
to the Theta Controller before replacing the fuse. Do not remove the cover. No
user serviceable parts inside.
1
Remove the Theta Controller from the dyno. Refer to Figure 1-26 or Figure 1-28.
2
Gently push the fuse holder slightly inward and rotate counterclockwise to
remove.
3
Replace the fuse. Refer to the table on page 1-25 for fuse replacement types.
For continued protection against risk of fire, replace only with a fuse of the
same type and having the same electrical rating.
Figure 1-32: Theta Controller—Replace the Fuse