Dynojet 150: Eddy Current Brake - Manual (Page 34)

Eddy Current Brake Installation Guide
C H A P T E R 1
Hood Upgrade
1-28
I NSTALLING THE H OOD
1 Verify the bolts and the set screws on the couplers are tight.
2 Connect the battery.
3 Carefully place the hood on the dyno leaving it propped up. Secure the key
switch, if present.
4 Lower and secure the hood using the four bolts removed earlier.
Verify the hood is not pinching or contacting any cables or wires.
Figure 1-38: Install the New Dyno Hood
5 Secure the hood clamps to the brake using the two bolts you removed earlier.
6 Secure the brake cover using the four bolts you removed earlier.
Never operate the dyno with this cover removed.
7 Plug the input power cable into a wall outlet.
Figure 1-39: Secure the Hood Clamps and Brake Cover
brake cover
hood clamps