CK Electric Part KX-FMC230 - Manual (Page 68)

68
1 2 3
4 5 6
7 8 9
0
Receiving using an extension telephone !
1 Press (MENU) .
Display:
2 Press K , then D A .
3 Press (START/COPY/SET) .
4 Press or to select the desired setting.
¡ If this feature is not required, select “OFF”.
5 Press (START/COPY/SET) .
6 Enter the new code number.
7 Press (START/COPY/SET) .
8 Press (MENU) .
SETUP ITEM [ ]
CODE= U 9
MODE=ON [ Ÿÿ ]
FAX ACT. CODE
SYSTEM SET UP
Using an extension telephone to receive fax
messages
!
If you have an extension telephone connected to your facsimile unit or on the same line, it is possible to
receive a manual fax message. Using the extension telephone, dial the fax activation code.
You do not have to go to the facsimile unit and press
(START/COPY/SET) .
Important:
¡ To activate this feature, use a touch tone telephone as the extension telephone and enter the fax activation
code FIRMLY.
¡ The fax activation code is set to “ U 9” as a pre-selected setting.
1 When a call is received, lift the handset of the
extension telephone.
2 When:
—document reception is required,
—a slow beep is heard, or
—no sound is heard,
enter the fax activation code FIRMLY.
3 Hang up the handset.
¡ The facsimile unit is set to receive documents.
Changing the fax activation code !
This code can be from 2 to 4 digits in length using numbers 0 through 9, and the character * .
Note:
¡ Some special telephone company services
will require you to press a service access
code. If you subscribe to such services, all or
part of the fax activation code must be
different from the service access code.
¡ If the fax activation code is set to “0000”, this
feature will not work properly.
To the EXT jack
or the same line
Extension telephone
(MENU)
(START/COPY/SET)
Dial keypad
Receiving Faxes