CK Electric Part KX-FMC230 - Manual (Page 98)

98
For Assistance, Call 1-800-435-7329
Operations
When a function does not work, check here before
requesting help
!
CAUSE & REMEDY PROBLEM
I cannot make and receive calls.
I cannot make calls.
The main unit does not work.
The handset does not work.
The main unit does not ring.
The handset does not ring.
The REDIAL/PAUSE button does
not function properly.
The receive mode does not function
as explained on pages 56 and 57.
During programming, I cannot enter
the fax activation code or the
remote TAM activation ID.
An alarm tone sounds when you
press
(TALK) or (INTERCOM) .
An alarm tone sounds continuously
while using the handset.
Static, sound cuts in/out, fades.
Interference from other electrical
units.
The unit stops working during
operation.
¡ The power cord or telephone line cord is not connected. Check the
connections (see page 21).
¡ The dialing mode setting is wrong. Check the setting and change
to TONE or PULSE (see page 42).
¡ Disconnect the unit from the telephone line and connect the line to
a known working telephone. If the working telephone operates
properly, call your service center to have the unit repaired. If the
working telephone does not operate properly, contact your
telephone company.
¡ Check the settings (see pages 27 and 28).
¡ Charge the battery fully (see pages 27 and 28).
¡ Clean the charge contacts and charge again (see page 115).
¡ The ringer volume is set to OFF. Adjust to a suitable level (see
page 29).
¡ The ringer volume is set to OFF. Press (LOUD/RINGER) when the
TALK/BATT LOW indicator light is off.
¡ If this button is pressed during dialing, a pause will be inserted. If
pressed immediately after a dial tone is obtained, the last number
dialed will be redialed.
¡ A distinctive ringing pattern is set (see page 66).
¡ Whole or part of the number is the same as another code or ID.
Change the number (see pages 62 and 68).
¡ You are too far from the main unit. Move closer and try again.
¡ Place the handset on the main unit and try again.
¡ The power cord is disconnected. Plug in the power cord.
¡ Move closer to the main unit quickly, or the call will be terminated
within 60 seconds.
¡ The power cord is disconnected. Plug in the power cord.
¡ Locate the handset and the main unit away from electrical
appliances.
¡ Move closer to the main unit.
¡ Raise the main unit antenna.
¡ Press (CH) to change the channel.
¡ Place the handset on the main unit and disconnect the power cord
to reset the unit. Connect the power cord, then try again.
General