Dynojet 250ix: Pre-Installation Guide - Manual (Page 15)

D Y N O P R E - I N S T A L L A T I O N I N F O R M A T I O N
Model 200i/250i Dynamometer
Version 3 Pre-Installation Guide for Model 200i/250i, 200iP/250iP, 250iX, and 250iPX Motorcycle Dynamometers
7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
MODEL 200I/250I DYNAMOMETER
The following specifications and requirements will help you set up your dyno area
and verify you have the requirements necessary to operate your dyno safely.
C HASSIS S PECIFICATIONS
description specifications
Length
with standard carriage allow 271.78 cm (107.00 in.)
with extended carriage allow 322.58 cm (127.00 in.)
with ramp in down position add 167.64 cm (66.00 in.)
Height
to top of dyno cover 45.97 cm (18.10 in.)
to top of ramp in up position 154.94 cm (61.00 in.)
Width
model 200i 106.68 cm (42.00 in.)
model 250i 179.60 cm (70.70 in.)
ramp 104.70 cm (41.22 in.)
Weight
model 200i dyno/crated dyno 725 kg (1,600 pounds)/771 kg (1,700 pounds)
model 250i dyno/crated dyno 1,077.28 kg (2,375 pounds)/1,133.98 kg (2,500 pounds)
Drum
diameter 45.72 cm (18.00 in.)
width 50.80 cm (20.00 in.)
Frame structural steel channel and angle
Maximum Horsepower 500 HP (373 KW)
Maximum Speed 200 MPH (322 KPH)
Maximum Motorcycle Length (front of
front wheel to center of rear wheel)
standard carriage 213 cm (84.00 in.)
extended carriage 256.54 cm (101.00 in.)
Remote Switches remote software control