Dynojet 250iPX: Installation Guide - Manual (Page 15)

M O D E L 2 0 0 I P X / 2 5 0 I P X U P G R A D E
Dyno Preparation
Version 1 Model 200iPX/250iPX Upgrade Installation Guide
1-7
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
DYNO PREPARATION
Use the following instructions to prepare the dyno for installing the upgrade kit.
If your monitor stand is installed on the right side of the dyno, you will need to use
the following instructions to move it to the left side of the dyno.
D ISCONNECTING THE P OWER
Use the following steps to connect and disconnect power to the dyno.
Always turn the power off when connecting and disconnecting cables.
1
Use the main breaker to turn power on and off to the dyno.
The main breaker is located inside the CPI door. When the handle is in the down
position all power into the dyno is turned off.
2 Disconnect the power plug to ensure all power has been removed from the dyno
before performing certain installation procedures.
Figure 1-4: Main Dyno Power
PD025
main breaker
power plug