Removing the monitor tray and arms – Dynojet 250iPX: Installation Guide User Manual
Page 19
Advertising
M O D E L 2 0 0 I P X / 2 5 0 I P X U P G R A D E
Dyno Preparation
Version 1
Model 200iPX/250iPX Upgrade Installation Guide
1-11
R
EMOVING
THE
M
ONITOR
T
RAY
AND
A
RMS
If your monitor stand is mounted on the left side of your dyno, skip to “Drum
Installation” on page 1-17.
1
Disconnect any cables to the control panel along with any other cables you may
have attached to the monitor arms and monitor tray.
Refer to the model 200iP/250iP installation guide for more information.
2
Remove the monitor tray and set aside.
3
Remove each arm and the washers and set aside.
Figure 1-8: Remove the Monitor Tray and Arms
second arm
poly washer
first arm
monitor tray
support arm
poly washer
poly washer
Advertising
This manual is related to the following products: