Dynojet 250iPX: Installation Guide - Manual (Page 30)

Model 200iPX/250iPX Upgrade Installation Guide
C H A P T E R 1
Drum Installation
1-22
5 Place two 1/4-inch thick poly washers around the pin on the tie-down without the
monitor arm.
6 Place the lower blower arm over the pin.
7 Place an aluminum washer between the clamp lever and the lower blower arm.
8 Secure the lower blower arm to the tie-down pin using the clamp lever.
9 Place a 1/8-inch thick poly washer around the pin on the upper blower arm.
10 Insert the pin on the upper blower arm into the lower blower arm.
11 Place a 1/8-inch thick poly washer around the pin on the blower.
12 Insert the pin on the blower into the upper blower arm.
13 Plug the power cord from the blower into the supplied blower extension cord
(P/N 76950317) and into the power source located on the junction box.
Note: This extension cord is only used with the blower mounted on the right side
of the dyno.
The blowers can run at any time once the cord is plugged into a power source.
Figure 1-17: Install the Right Blower Assembly
right blower
assembly
plug power cord from
blower into junction box
aluminum washer
1/4-inch thick
poly washer
lower blower
arm clamp lever
upper blower
arm