Dynojet 250iPX: Installation Guide - Manual (Page 39)

B A S I C D Y N O O P E R A T I O N
Loading the Vehicle
Version 1 Model 200iPX/250iPX Upgrade Installation Guide
2-3
5 When the vehicle is positioned properly on the dyno, shut the engine off.
• If the vehicle has an automatic transmission, place it in park.
• If the vehicle has a manual transmission, place it in gear.
6 Attach two tie-down straps from the ground hooks to the rear of the vehicle.
7 Attach two tie-down straps from the ground hooks to the front of the vehicle.
Note: If you are running an all wheel drive ATV, use differential jacks to get the
front wheels off the dyno.
Note: When running an ATV, you may need to increase the tire pressure so the
tire does not come in contact with the decking.
8 Tighten the four tie-down straps evenly making sure the drive wheels remain
centered on the drum.
Never perform a dyno run if the tie-down straps are not in place or they are
damaged.
Figure 2-2: Loading the Vehicle—Top View