Configure sata as, Primary ide master, Primary ide slave – Kontron AM5010 BIOS User Manual

Page 28: Secondary ide master, Secondary ide slave, Third ide master

Advertising
background image

Advanced Setup

AM4010/AM4011/AM5010 BIOS

Page 18

ID 1022-2060, Rev. 2.0

Configure SATA as

This function controls the SATA controller device's operating mode and is only available if the
ATA/IDE Configuration is set to Enhanced.

Optimal and Fail-Safe default settings when ATA/IDE Configuration is set to Enhanced: IDE

Primary IDE Master

This function provides access to the Primary IDE Master sub-screen. To access the Primary
IDE Master screen, select this function and press <Enter>.

Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.

Primary IDE Slave

This function provides access to the Primary IDE Slave sub-screen. To access the Primary IDE
Slave screen, select this function and press <Enter>.

Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.

Secondary IDE Master

This function provides access to the Secondary IDE Master sub-screen. To access the Sec-
ondary IDE Master screen, select this function and press <Enter>.

Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.

Secondary IDE Slave

This function provides access to the Secondary IDE Slave sub-screen. To access the Second-
ary IDE Slave screen, select this function and press <Enter>.

Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.

Third IDE Master

This function provides access to the Third IDE Master sub-screen. To access the Third IDE
Master screen, select this function and press <Enter>.

Refer to the Primary IDE Master screen below for further details concerning device configura-
tion functions.

SETTING

DESCRIPTION

IDE

Use this setting to specify that the SATA controller is to operate as a legacy IDE controller.
In this case, old IDE drivers may be used.

AHCI

Use this setting to specify that the SATA controller is to operate as an AHCI controller.
In this case, AHCI drivers must be used.

Advertising
This manual is related to the following products: