Kontron JRexplus-DC - Manual (Page 23)

KTD-S0008-F Page 18 Graphics Interface
JRexplus-DC User's Guide
7.7 Extended VESA Modes
VESA Mode Type Pixels Colors
101h Graphic 640 x 480 256
103h Graphic 800 x 600 256
105h Graphic 1024 x 768 256
107h Graphic 1280 x 1024 256
111h Graphic 640 x 480 64k
112h Graphic 640 x 480 16M
114h Graphic 800 x 600 64k
115h Graphic 800 x 600 16M
117h Graphic 1024 x 768 64k
118h Graphic 1024 x 768 16M
11Ah Graphic 1280 x 1024 64k
11Bh Graphic 1280 x 1024 16M
7.8 Backlight Connector
Backlight is available through the J96 connector (7 pins). Backlight voltage and backlight on/off polarity
are controlled through the jumper J5 and J3. The backlight brightness (adjust voltage) can be set in the
BIOS Setup.
Header Pin Signal Name Function
1 N.C. Not connected
2 BKLTADJ Brightness control (0V - 5V)
3 GND Ground
4 VCC 1) Power +5V or +12V
5 VCC 1) Power +5V or +12V
6 GND Ground
7 BKLTON Backlight on/off
Note: 1) To protect the external power lines of peripheral devices make sure that
- the wires have the right diameter to withstand the maximum available current.
- to enclosure of the peripheral device fulfills the fire-protecting conditions of IEC/EN 60950.