Kontron JRexplus-DC - Manual (Page 43)

KTD-S0008-F Page 38 Crisis Management
JRexplus-DC User's Guide
20 Crisis Management
Modifying parameters in the BIOS Setup implies the risk of leaving your system in an unbootable state. In
case this happens one jumper exists to reset the settings to 'Fail-Safe' values.
To Reset to 'Fail-Safe' values please take the following steps:
Power down the board
Jumper J101 must be set
Power up the board - BIOS Setup enters automatically
Before saving your new settings with 'Save Changes and Exit' remove the jumper
The board should be functional again now
21 Autostart Function
When the JRexplus-DC should start directly when the power is applied (without a power button signal) the
autostart jumper J102 must be set.