Kontron KISS 1U Short KTQM77 Users Guide - Manual (Page 18)

7. Product Description KISS 1U Short – User’s Guide (V1.10)
7.3. Side View
The four M4 metric tapped holes (Fig. 12, pos. 3) are available at the left and right side of the unit. These can be used in
order to attach slide rails (not included in the scope of delivery) to the KISS 1U Short platform for system installation into
a 19” industrial cabinet. Refer to the chapter 11 “Slide Rails (Option)”.
3 2 1
Fig. 12: Side view with tapped M4 metric holes to attach a telescope rail
1 Side view of the KISS 1U Short platform
2 4x tapped M4 metric holes (on both sides)
3 Cover with captive knurled screws (to secure
the cover to the unit)
7.4. Cover
The cover will be fixed to the chassis using three fixing brackets (Fig. 13, pos. 3) and three captive knurled screws (Fig.
13, pos. 1). The fixing brackets are located on the inside of the cover at the front edge. When closing the cover, make sure
that the fixing brackets (Fig. 13, pos. 3) will be inserted properly into the corresponding retaining brackets for the cover (
Fig. 5, pos. 10) on the rear side of the chassis.
1
2
4
3
Fig. 13: Inside of the cover with fixing brackets
1 Captive knurled screws
2 Insulation foil (Makrolon) 3 3x front fixing brackets
4 Inside of the cover
16 www.kontron.com