Kontron KISS 1U Short KTQM77 Users Guide - Manual (Page 26)

10. Maintenance and Prevention KISS 1U Short – User’s Guide (V1.10)
10.
Maintenance and Prevention
Kontron Embedded Computers systems require minimal maintenance and care to keep them operating correctly.
‰ Occasionally wipe the system with a soft dry cloth.
‰ You should only remove persistent dirt by use of a soft, slightly damp cloth (use only a mild detergent).
‰ Clean the air filter mats regularly (refer to the “Cleaning the Filter Mat” section).
10.1. Replacing the Lithium Battery
The integrated motherboard of your system is equipped with a lithium battery. To replace the battery, please proceed as
follows:
1. Open the unit as described in the chapter 8.2.1 “Installing/Removing the Expansion Cards” (step 1-4).
2. Remove the old battery by pressing outwards on the ejector spring.
3. Place the new battery into the socket.
4.
Make sure that you insert the battery the right way around. The plus pole must be on the top!
5. The lithium battery must be replaced with an identical battery or a battery type recommended by Kontron Embedded
Computers. The Lithium battery type must be UL listed.
6. Close the unit as described in chapter 8.2.1 “Installing/Removing the Expansion Cards” (step 12).
Caution
Danger of explosion when replacing with wrong type of battery. Replace only with the same or equivalent
type recommended by the manufacturer. The lithium battery type must be UL recognized.
Do not dispose of lithium batteries in general trash collection. Dispose of the battery according to the
local regulations dealing with the disposal of these special materials, (e.g. to the collecting points for
dispose of batteries).
10.2. Replacing the System’s Fans
The operation of the KISS 1U Short is permitted only with functional fan modules.
Defective components should only be replaced only by Kontron.
24 www.kontron.com