Kontron KISS 1U Short KTQM77 Users Guide - Manual (Page 23)

8. Assembly, Disassembly KISS 1U Short – User’s Guide (V1.10)
8.3. Instruction for Installation in a 19” Cabinet
In order to setting-up installing / removing the KISS 1U Short platform into/from a 19" industrial
cabinet, please observe the instructions described in this manual.
The system has to be mounted and installed only by the service person for this area familiar with the
associated dangers.
Ensure there is sufficient air circulation around the device when installing the KISS 1U Short platform.
The openings for air intake and exhaust on the device must not be obstructed by objects.
Leave at least 5 cm (1.969 ") of free space in front and behind the unit to prevent the device from possibly
overheating!
The KISS 1U Short platform should be installed into a 19" industrial cabinet with slide rails.
The 19" industrial cabinet must stand firmly in place. You can improve its stability by placing the
components into it from the bottom up. Heavy components should be placed down below.
If further stabilization is necessary, then bolt the 19" industrial cabinet to the floor or anchor it on the
wall.
The voltage feeds must not be overloaded. Adjust the cabling and the external overcharge protection to
correspond with the electrical data indicated on the type label.
The type label is located on right side of the unit.
www.kontron.com 21