Kontron KISS 1U Short KTQM77 Users Guide - Manual (Page 20)

8. Assembly, Disassembly KISS 1U Short – User’s Guide (V1.10)
8.
Assembly, Disassembly
8.1. Attaching the Rubber Feet
The rubber feet can be used for the desktop version of the system. Please follow these steps to attach the rubber feet to
the bottom side of the chassis:
1. Turn your system off and disconnect it from the mains supply.
2. Make sure that all cards are secured into unit and that the system cover is installed and secured.
3. Turn the system upside down.
4. Remove the protect foil from the delivered self adhesive rubber feet.
5. Attach the self adhesive rubber feet to the bottom side of the chassis.
8.2. Accessing Internal Components
This section contains important information that you should read before accessing the internal components. You should
follow these procedures when handling any expansion cardboards.
8.2.1. Installing/Removing the Expansion Cards
When you install (or remove) expansion cards please consider the corresponding safety instruction of
the included “General Safety Instruction for IT Equipment”.
Activities such as working inside the system or handling the expansion cards have to be carried-out by
the service person for this area or a suitably instructed user.
Please observe the safety instruction for handling assemblies with static sensitive device. Failure to
take heed of this warning instruction can result in damage to the device.
Please consult the documentation provided by the manufacturer of the expansion card for instructions
before attempting to install/remove an expansion card into/from the KISS 1U Short platform.
To install or remove an expansion card, perform the following steps:
1. Turn off your system and disconnect the power cord from the mains.
2. Loosen the fastening screws on the rear side of the unit that secure the cover.
Fig. 15: Loosening the three fastening screws on the rear side of the KISS 1U Short system
18 www.kontron.com