Kontron KISS 1U Short KTQM77 Users Guide - Manual (Page 22)

8. Assembly, Disassembly KISS 1U Short – User’s Guide (V1.10)
4 3
5 6
8 7
5
3 2 2
1
Fig. 20: Detail with opened slide brackets for
2x PCI-card slots (Config. with KTGM45)
Fig. 21: Detail closed slide brackets,
1x PCIe x16-card slot (Config. with KTQM77)
Legend for Fig. 20 and Fig. 22:
1 Free expansion slots for 2x PCI cards or with
another adapter 1x PCIe x16 expansion card
(Config. with KTGM45)
2 Slots for expansion cards
3 Fastening screws of the slide brackets
4 slide bracket (opened)
5 Card holder
6 Free expansion slots for 1x PCIe x16 card (Config.
with KTQM77)
7 2x COM (RS232) (available only in config. with
KTQM77)
8 Slide bracket closed
7. Insert/remove the expansion card into/out of the PCI/PCIe slot.
8. Position the bracket of the expansion card or the slot bracket at the rear side of the chassis.
9. Move the slide bracket (Fig. 20, pos. 4) to the right until it rests firmly on the brackets of the expansion cards and the
slot bracket, respectively.
10. Lock the slide bracket in this position by fastening retained the screws ( Fig. 18 , pos. 2) firmly.
11. Secure the slide bracket position with the fastening screws (Fig. 20, pos. 3)
12. Close the device and secure the cover with the fastening screws (Fig. 10, Fig. 13, pos. 1) on the rear side.
When closing the cover, make sure that the cover fixing brackets (Fig. 13, pos. 3) slide into the
corresponding retaining brackets ( Fig. 5, pos. 6) of the chassis.
20 www.kontron.com