Kontron KISS 4U X9DR3 - Manual (Page 20)

7. Product Description KISS 4U V2 EATX – User's Guide (Version 1.02)
7.1.3.1.
Power- and HDD-LED
The power LED marked “PWR” and the hard disk LED marked “HDD” (Fig. 15) of the KISS 4U V2 EATX platform are located
on the front side, behind the front access door.
1 2
1 Power LED
2 HDD activity LED
Fig. 15: Power and HDD LED on the front side
Power LED
(green) This LED (Fig. 15, pos. 1, Fig. 13 and Fig. 14) lights up green when the system is turned on via the
power switch of the PSU and the power button.
Prerequisite:
The system has to be connected to an appropriate AC/DC main power source.
Please observe the settings option for “Restore on AC Power Loss” in the BIOS Setup.
HDD LED
(yellow) This LED (Fig. 15, pos. 2, Fig. 13 and Fig. 14) lights up during hard disk activity.
7.1.3.2.
Gigabit Ethernet (GbE LAN) LEDs
These two LEDs on the front side (see Fig. 13, Fig. 14 and Fig. 16) and marked “LAN1” and “LAN2”, lights up/flashing,
when Ethernet Link/Activity is established/detected.
Fig. 16: LAN2 and LAN1 LED on the front side
7.1.3.3.
SYSID LED and Button (available in KISS 4U V2 KTC5520 Platform only)
This SYSID button (see Fig. 13, and Fig. 17, pos. 1) allows you to power on the SYSID LED (Fig. 17, pos. 2), in order to
mark the system for an intended maintenance/retrofitting. The SYSID LED may be powered off via this SYSID button.
2
1 SYSID button
2 SYSID LED
1
Fig. 17: SYSID LED and SYSID button on the front side
The KISS 4U V2 X9DR3F platform is not equipped with the SYSID LED and SYSID button (refer to Fig. 14).
Two covering caps are inserted into the mounting holes for SYSID LED and SYSID button.
18 www.kontron.com