Kontron KISS 4U X9DR3 - Manual (Page 29)

8. Assembly, Disassembly KISS 4U V2 EATX – User's Guide (Version 1.02)
8.
Assembly, Disassembly
8.1. Attaching the Rubber Feet
If the system is used as desktop/tower device, the rubber feet (included) can be attached to the system.
To attach the rubber feet to the chassis, please perform the following steps:
1. Turn your system off and disconnect it from the main power supply.
2. Make sure that all cards are secured into unit and that the system cover is installed and secured.
3. Turn the system upside down for desktop version and lie it down sideways for the tower version.
4. Remove the protective film from the self adhesive rubber feet.
5. Attach the self adhesive rubber feet to the corresponding side of the chassis.
If you operate the KISS 4U V2 EATX platform in vertical position, please observe that the system fans (slide-
in module) must be to the lower front and the drives to the upper front side of the system (see
Fig. 6).
8.2. Cover
The cover will be fixed to the chassis using two fixing brackets at the front side of the cover (Fig. 30, pos.3 and pos. 4),
two fixing brackets with captive knurled screws at the rear side of the cover (Fig. 30, pos.6) and the cover fastening screw
(Fig. 11, pos. 11) at the front side of the KISS 4U V2 EATX platform.
When inserting the cover, make sure that the fixing brackets (Fig. 30, pos. 3 and pos. 4) are inserted properly into the
corresponding retaining bracket of the chassis (Fig. 8, pos. 4). The centering bracket (Fig. 30, pos. 3) and the front cover
fastening screw (Fig. 11, pos. 11) secure the cover on the front side.
5 6
Fig. 30: Inside of the cover with fixing brackets
1 Inside of the cover
2 Front part of the cover
3 Angled centering bracket with tapped hole
(on the front side)
4 Fixing bracket (on the front side)
5 Rear part of the cover
6 Fixing brackets with knurled screws
2 4
1
3
www.kontron.com 27