Rice Lake 920i FlexWeigh Systems - 104 - Manual (Page 11)

Entering the Setup Menu 7
3.0 Setup Menu
The System 104 Loss-in-Weight Dispensing Controller has various setup parameters. They are explained in further
detail in the following sections.
3.1 Entering the Setup Menu
Note that the front panel E-stop button must be in the stopped position (pushed in) to enable the following
keypad entries.
1. Press the Setup Menu softkey on the main menu screen and the system performs one of the following
actions.
• If a system password is entered, proceed to Step 2.
• If no system password is entered, the Setup Menu Main Screen will display (see Figure 3-2).
2. Press the Setup Password softkey. The system prompts with Enter Password .
Figure 3-1. Setup Menu Enter Password
3. Enter the password and press the ENTER key on the 920i.
4. The system checks the entered value against the system password.
• If the password is valid the Setup Menu Main Screen will display (see Figure 3-2).
• If the password is invalid, Invalid password will display momentarily and display exits the operation.
Figure 3-2. Setup Menu Main Screen
Note
06/02/2011 02:15PM SCALE #1
Cancel End
Enter New Password
=>
_ _ _ _ _
SCALE #1
Gross
Lb
Home
Program: Express 104 PN120599 V 1.00
ID #1 (disabled) Start O Disp Cmpt
ID #2 (disabled) Resume O Slow Cycle
Single-Speed (enabled) Reset O Disp Slow
Auto Print (disabled) Stop O Disp Fast
Delay After Discharge (sec) 3.0
Setup Menu
06/02/2011 02:15PM SCALE #1
ID #1 More=>
Setup Menu
_ _ _ _ _
SCALE #1
Gross
Lb
Time/Date
Program: Express 104 PN120599 V 1.00
ID #1 (disabled) Start O Disp Cmpt
ID #2 (disabled) Resume O Slow Cycle
Single-Speed (enabled) Reset O Disp Slow
Auto Print (disabled) Stop O Disp Fast
Delay After Discharge (sec) 3.0
Setup Menu
Setup
Password
ID #2