5 modifying the dispensing speeds, 6 modifying auto print – Rice Lake 920i FlexWeigh Systems - 104 User Manual
Page 14
10
System 104 Loss-in Weight Dispensing Controls
3.5
Modifying the Dispensing Speeds
Use the following steps to modify the dispensing speeds.
1. From the
Main Setup Menu Screen
, press the
Setup Password
softkey.
2. Press the
More=>
softkey to access the second and third menu screens.
Figure 3-7. Setup Main Menu Screen #2
3. Press the
Single Speed Enabled, Dual Speed Enabled
or
Parallel Speed Enabled
softkey.
4. The system will toggle between the three modes of operation.
3.6
Modifying Auto Print
Use the following steps to modify the auto print.
1. From the
Main Setup Menu Screen
, press the
More=>
softkey to access the second setup menu screen.
2. Press the
Auto Print Enabled
or
Auto Print Disabled
softkey.
Figure 3-8. Auto Print Disabled Softkey
3. The system will toggle between the two modes of operation.
06/02/2011
02:15PM
SCALE #1
Auto Print
Disabled
More=>
_ _ _ _ _
SCALE #1
Gross
Lb
<=More
Program: Express 104 PN120599 V 1.00
ID #1 (disabled)
Start
O
Disp Cmpt
ID #2 (disabled)
Resume O
Slow
Cycle
Single-Speed (enabled)
Reset O
Disp
Slow
Auto Print (disabled)
Stop
O
Disp Fast
Delay After Discharge (sec) 3.0
Setup Menu
Single-Spd
Enabled
Delay
After Disch
Auto Print
Disabled