Rice Lake 920i FlexWeigh Systems - 201/202 - Manual (Page 17)

Softkey Setup 13
3.4 Entering the Setup Menu
Note
The front panel E-stop button must be in the stopped position (pushed in) to enable any of the following
keypad entries.
1. Press Setup Menu on the main menu screen.
If a system password is stored, proceed to Step 2.
If no system password is stored, setup menu will be displayed (see Figure 3-5). Proceed to next section.
2. Enter password when system prompts Enter Password .
08/27/2012 02:15PM SCALE #1
End
Enter Password=>
SCALE
#1
Gross
Lb
SETUP MENU
Program: Express 202 PN126057 Ver 1.00
ID #1: (Disabled)
ID #2: (Disabled)
Dual-Speed Enabled
Auto Print Disabled
Delay After Discharge (sec) :3.0
Zero Tolerance Weight: 0.04 lb
Discharge Option Disabled
Home Cancel
0.00
Figure 3-4. Setup Menu Enter Password
3. Press ENTER .
The system checks the entered value against the system password and performs one of the following
actions:
- Valid entry - displays the setup menu screen and softkeys.
- Invalid entry - Momentarily prompts -
Invalid password and exits this sequence of operation.
When the system password criteria is satisfied the following display is shown.
ID #1 More =>
SETUP MENU
Time/Date
Setup
Password
ID #2
Program: Express 202 PN126057 Ver 1.00
ID #1: (Disabled)
ID #2: (Disabled)
Dual-Speed Enabled
Auto Print Disabled
Delay After Discharge (sec) :3.0
Zero Tolerance Weight: 0.04 lb
Discharge Option Disabled
0
08/27/2012 02:15PM SCALE #1
Setup Menu
0.00 SCALE
#1
Gross
Lb
Figure 3-5. Setup Menu Main Screen