Rice Lake Tracer AV - Manual (Page 15)

Tracer AV Installation Manual - Configuration 11
3.1.3 Front Panel Configuration
The Tracer AV can be configured using a series of menus viewed on the RD-1 display when the Tracer AV is in
setup mode. Table 3-1 summarizes the functions of each of the main menus.
The two-button numeric editor works as follows:
Press Units to navigate RIGHT. Press Zero to drop DOWN or select from a list of values.
Figure 3-2. Setup Mode Menu Navigation
3.1.4 Setting Numeric Values For Parameters
1. Press Zero to immediately accept the current value and navigate to the next menu item.
2. Press Units to enter edit mode.
The leftmost digit will flash to indicate it can be altered.
3. Press Zero to increment to the desired value.
4. When the value is correct, press Units to move to the next digit.
Menu Menu Function
DEFCAL Default
Configuration Select a 500lb or 300lb default configuration. You can also display and edit zero calibration a/d
count value, test weight value, and span calibration a/d count value.
CONFIG Configuration Configure grads, zero tracking, zero range, motion band, overload, tare function, sample rate,
and digital filtering parameters.
FORMAT Format Set format of primary and secondary units, display rate.
CALIBR Calibration Calibrate Tracer AV . See Section 4.0 on page 23 for calibration procedures.
SERIAL Serial Configure EDP and printer serial ports.
PROGRM Program Set power-up mode, regulatory mode, and consecutive number values.
SETPNT Setpoint Configure Setpoints and digital outputs.
VERS Version Display installed software version number.
Table 3-1. Tracer AV Menu Summary
Button Function
Zero Move DOWN/ Increment Value
Units Move RIGHT/Next
Table 3-2. Button Functions in Setup Mode
1 st Level
Parameter
Default value Value
1 st Level
Parameter
2 nd Level
Parameter
2 nd Level
Parameter
Value Value
When moving through values below the first menu, press UNITS to view the
selections. Press ZERO to set the parameter and move to the next parameter on the
leval above.