Rice Lake Equipoise Series, Rice Lake Weighing Systems - Manual (Page 16)

12 Equipoise Series Technical Manual
Table 5-1. Parameter Settings
Menu Sub Menu Description
F1 unt g / ct / lb / oz / d / gn / ozt /
dwt / mm / tl.T / tl.c / tl.t / t,. To set units, each one can be set to on or
off.
F2 el El au On When weight is on the pan the backlight
will turn on.
Off
El on On Backlight is always on when balance is
turned on.
Off
El off On Backlight is always off when balance is
turned on.
Off
F3 com P prt By pressing Print key , weighing value will
be added to the memory and send to
printer if connected.
P cont Sends data continuous.
P auto Automatic accumulation.
Individual weighing values are automatically
added
Set BAUD rate
After setting the RS 232 mode, display will be shown current baud rate b
XXX.
Baud rate Options: b600, b1200, b2400, b4800 and b9600
Set Printer type
After setting BAUD rate display will be show the printer type
Lp 50 Not Available
Tp Ticket Printer
F4 ACC ACC ON Turn on accumulation
ACC OF Turn off accumulation
tech pin Factory Access Only
P 1 lin Linear Calibration
P 2 Cal Normal Calibration
P 3 cnt xxxx This display will show XXXXX for indicating
the internal counts
P 4 a 2n 0 .5 d To set auto zero
1 d
2 d
4 d
P 5 gra Xxxx To set local gravity