Rice Lake Intercomp CS 750 - Users Manual - Manual (Page 7)

CS750, Users
Rev R, May 2009
Page 7 of 27
ON
Press this button to turn the scale on. The scale tests itself; when these tests
have completed successfully, the system begins weighing.
Note: If you used the remote control to turn off the scale (the last time), you must
first press the OFF key, then press the ON key.
OFF
Press this button to turn the scale off.
ZERO
Tells the scale to display a zero weight. This button is used any time the scale
shows a non-zero value with no weight on the hook. If you press ZERO with
weight on the hook, that weight becomes the zero condition for the scale. This
can be useful to cancel the weight of any weighing fixtures, such as containers,
chains or cables. When this weight is removed, a negative weight shows until
the system is zeroed again. NOTE: The “zero” command will be delayed any
time a change in weight is detected. If there is continuous motion for more than
20 or 30 seconds, the zero command will be rejected and the scale will return to
normal weighing.
NOTE: The scale contains a feature called Auto Zero Tracking (AZT), which
corrects for slight zero changes during normal operation. If small weights are
added slowly, the scale could zero them off.
BACK LIGHT
Turns the back light on or off for the LED display.
Hidden key
The switch referred to as the hidden key is unlabeled and located directly to the
left of the ZERO key. This switch has no function except during calibration.