Rice Lake Remote Displays/Scoreboards - Laser LT - Manual (Page 20)

16 Laser LT Installation and Operation Manual
E CHAR CR
LF
FF
ETX The Laser LT scans for this character to determine the end of a packet.
LW POS 000000 Defines the position of the last character in a weight. Range 0-63 with 0 as the
default.
• With a 0 setting, the Laser LT will search from the end of the data stream
for the first group of digits.
• With a non-zero setting, the Laser LT will begin searching for digits at the
specified location.
• If LWPOS is past the weight in the data stream, it will work its way back to
the first group of digits it finds.
• A custom setting of this parameter is how a particular value is displayed
from a multi-weight data stream.
SUPP O On
Off Enable (on) or disable (off) leading zero suppression.
PRI CHR L = 76 Allows the user the select the primary unit character
PRI LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
SEC CHR K - 75 Allows the user to select the secondary unit character
SEC LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
GRS CHR G - 71 Allows the user to select the gross character
GRS LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
NET CHR N - 78 Allows the user to select the net character
NET LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
MOT CHR M - 77 Allows the user to select the motion status character
MOT LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
NEG CHR [-] 45 Allows the user to select the negative polarity status character.
NEG LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
OVR CHR O - 79 Allows the user to select the overload status character.
OVR LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
COZ CHR Z - 90 Allows the user to select the center of zero status character
COZ LOC 000000 This is the character location in the string format. A 0 (zero) indicates that the
Laser LT will look for the character anywhere in the incoming data. The range is
0-63
CONFIG Menu
Table 3-2. Configuration Menu Summary - Level 2