Rice Lake Remote Displays/Scoreboards - Laser LT - Manual (Page 9)

Installation and Setup 5
2.0 Installation and Setup
WARNING
CAUTION
The Laser LT remote display can be easily set up and configured. This section describes basic installation, AC
wiring, RS-232 and 20mA current loop connections. Once installation setup is complete, go to Section 3.0 for
information on configuring the Laser LT.
Use a wrist strap to ground yourself and protect components from electrostatic discharge (ESD) when
working inside the enclosure.
The Laser LT has no on/off switch. Before opening the unit, ensure the power cord is disconnected from
the power outlet.
2.1 Unpacking and Assembly
Immediately after unpacking, visually inspect the Laser LT remote display for damage. If any parts were damaged
in shipment, notify Rice Lake Weighing Systems and the shipper immediately. The shipping carton contains the
remote display, a parts kit, and this manual. Parts kits contents are listed in Table 6-5 on page 35.
2.2 Wall Mounting
The Laser LT remote display can be mounted to any vertical surface.
Select a site for installing the Laser LT. The unit has four keyhole slots on the outer flange of the unit and uses four
installation screws or wall anchors to secure the remote display to a wall.
Four keyhole slots
(only two shown)
Figure 2-1. Keyhole Slots for Mounting
Once the enclosure is secured, the front cover can be unlatched to access inside of the enclosure.
Two latches secure the lid of the
Laser LT
Figure 2-2. Enclosure Latches