Rice Lake Remote Displays/Scoreboards - Laser LT - Manual (Page 34)

28 Laser LT Installation and Operation Manual
4.3 Reporting Commands
Reporting commands send specific information to the serial port.
Table 4-3. Laser LT Reporting Commands
Parameter Function
DUMPALL Lists all configuration parameters.
DUMP.KEYPAD Lists only the 10 keypad parameters.
DUMP.PORT Lists only the 4 ports with 4 parameters per port.
DUMP.SY List the parameters not dumped with the other commands.
BUILD Lists the date and time that this software version was compiled.
SYSMODE Returns the current mode in Run or Setup.
VERSION Returns the software version.
WHOAMI Returns the version of the Laser LT and the port that you are connected to and its parameters.
COMMOPTS 7 = Empty
1 = RS-232/422
2 = USB/Serial
3 = Reserved
4 = Ethernet WiFi/Serial
5 = Ethernet
6 = Fiber Optic
Read only. Returns a numeric identifier for an installed option card
Note
All Reporting commands are read only and will not function for baud rates lower than 4800.
PORTS 1 THRU 4 BAUD = 9600
BITS = 8 NONE
ECHO = ON
SBITS = 1 STOP BIT
KEYPAD 1 ENABLE = ON
STRING = KZERO<13> Keypad strings are captured using the following format for all 5 keys:
KEYPAD1.STRING = <KZERO<13>
KZERO is a string which can be up to 32 characters
<13> is the ASCII for carriage return.
KEYPAD 2 ENABLE = ON
STRING =
KGROSSNET<13>
KEYPAD 3 ENABLE = ON
STRING = KTARE<13>
KEYPAD 4 ENABLE = ON
STRING = KUNITS<13>
KEYPAD 5 ENABLE = ON
STRING = KPRINT<13>
Command Choices Description
Table 4-2. Laser LT Parameter Setting Descriptions