Rice Lake Remote Displays/Scoreboards - Laser LT - Manual (Page 29)

Configuration 25
Configuration menu found in Figure 3-15
Keypad menu found in Figure 3-16
Digital I/O menu found in Figure 3-15
Figure 3-16. Keypad Setup
3.10.2 Comm Ports
Select the Comm Ports icon to access and set up Ports 1
through 4 information such as baud rate, data bits,
stopbits and echoing.
Figure 3-17. Comm Port Screen
See Figure 3-6 for more information on setting these
parameters.
3.10.3 Formatting
Note
Information must be uploaded prior to using
the Formatting screen in Revolution.
With Revolution running and the new file screen
shown (from Figure 3-14), select
Communications from
the upper toolbar. Select Connect and then select
upload configuration.
Select the Formatting icon to access the general
formatting screen shown in Figure 3-18. This would
generally be used when the Laser LT Auto Learn failed
to display weight or annunicators. By viewing
information on the screen, you are able to see what
information the Laser LT has captured. Changes can be
made and downloaded to the Laser LT to customize the
display weight and annunicators.
Figure 3-18. Formatting Screen
From this screen you can set up annuciator and weight
parsing.
The first text box on the screen shows the last received
data that the LaserLT sends when data is uploaded.
This is a "snapshot" of 50 characters that the LaserLT
received from the host. It will display the ASCII value
of each character in the frame. Use the start character
and end character's ASCII values to determine the
frame. Characters between the start and end characters
make up the frame. You should only refer to the first
full frame. There may be half of a frame at the
beginning due to the timing of when the LaserLT sent
the "last received" data.
Look at each location to see what it is and what token
needs to be updated.