Rice Lake Remote Displays/Scoreboards - Laser LT - Manual (Page 33)

EDP Commands 27
4.2 Parameter Setting Commands
The following table describes EDP parameter setting commands with descriptions and ranges.
Command Choices Description
DAISY OFF
PORT 1
PORT 2
PORT 3
PORT 4 This is the port that will echo the weight data to another remote display
DIO1 OFF
REDLED
GRNLED
ZERO
TARE
UNITS
PRINT
GRSNET Select which LED or front panel key function is controlled by this digital I/O
point. Note: DIO1 and DIO2 could both be set to the same front panel key
function.
DIO2 OFF
REDLED
GRNLED
ZERO
TARE
UNITS
PRINT
GRSNET Select which LED or front panel key function is controlled by this digital I/O
point. Note: DIO1 and DIO2 could both be set to the same front panel key
function.
HOLDWEIGHT OFF
ON Holds the last received weight on the display instead of showing an error if
communications are lost or the host is sending demand data.
HOST PORT 2
PORT 1
PORT 3
PORT 4 The port to receive weight data from the indicator on.
INTENSITY 7
1
2
3
4
5
6 The intensity of the LED elements with 1 = dimmest and 7 = brightest
KEYDST PORT 2
OFF
PORT 1
PORT 3
PORT 4 This is the port that will transmit keypress commands.
LOCK OFF
ON Locks (on) or unlocks (off) access to the Learn Mode.
NODATA NO COM
BLANK This parameter allows the display to either display NO COM or go blank
when data transmission is lost, unless over-ridden by the hold weight
parameter.
STANDSTILL OFF
ON Select On to blank the display when the scale is in motion.
STARTUP ON
OFF This defines whether or not to do a display check and version display on
power up.
On = this performs the test and shows the version
Off = this goes straight into the operation
SUPPRESSZERO ON
OFF Enable (on) or disable (off) leading zero suppression.
Table 4-2. Laser LT Parameter Setting Descriptions