Rice Lake MSI-8000 RF Remote Display - Manual (Page 10)

6 MSI-8000 Operator’s Manual
1.3 Specifications
Table 1-2. Specifications
Accuracy
Power
Display
Operating Temp
Operating Time
Enclosure
F1, F2, and F3
Calibration
Auto-Off Mode
Units
Totalization
Set Points
Weight accuracy is dependent on the linked Tension unit, a Dyna-Link or
MSI Crane scale. Refer to the appropriate User Guide for accuracy
specifications. The MSI-8000 mirrors the display of the connected
device.
Battery operated by a custom Lithium Polymer cell. Not user
replaceable. Estimated number of charges is >300. Life is prolonged
with frequent recharging and not allowing the deep discharging of the
battery.
6 large, 1 in (26 mm) numeric digits
- 40°F to +122°F (-40°C to +50°C), Rated accuracy range -10°C to
+40°C.
>24 hours typical.
NEMA 4/IP65 with charger port plug installed.
Programmable multifunction buttons for use as TEST, TOTAL, Total
Remote Devices, PEAK, TARE, NET/GROSS, VIEW TOTAL, PRINT and
High Res mode
No Calibration parameters are stored in the MSI-8000 . However, it can
be used to calibrate an RF connected scale
Prolongs battery life by turning the power off after 15, 30, 45, or 60
minutes (operator determined) of no weight activity
kg, lb., Tons (US short ton), Metric Tons, kiloNewtons (other Units
available with custom calibrations). Available units are determined by the
RF Linked Scale/Dyna-Link
Standard: Press button or Automatic; TOTAL weight up to 999999 X
1000 units
Two internal Set Points with open drain outputs, and two ultrabright
LEDs on indicator panel.