Rice Lake MSI-8000 RF Remote Display - Manual (Page 12)

8 MSI-8000 Operator’s Manual
1.7 Getting Started
The MSI-8000 is usually shipped along with a compatible sensor unit such as an MSI-7300
Dyna-Link 2, or one of MSI’s advanced Crane Scales. MSI always ships these systems
pre-configured. If the MSI-8000 is purchased separately, or is to be used with a different
system, then the RF Transceivers will have to be mated. Follow the RF Setup Procedure in
Section 5.1.
Fully charge the battery by plugging the charger into the Charge Port. Depending on the
discharge level of the battery this can take up to 6 hours.
Once the RF Setup is complete for the MSI-8000, the system will instantly connect with
the Scale / Dyna-Link. It is advised to do a site survey to identify operating range and
usability of the RF Link. The easiest way to accomplish this is to position the Scale /
Dyna-Link at an average operational height, and then try the link at various positions and
distances. Range may vary by the rotation of the Scale / Dyna-Link. The RF Transceivers
used in the MSI-8000 are capable of much further range than the 100’ typical spec, but
range is dependent on site and installation variables.
1.8 Options
Available options for your MSI-8000 include the following:
• Serial I/O cable (RS-232) MSI PN 503489-0001 DCE Configuration, 503489-0002
DTE Configuration
• Serial I/O cable (RS-232) with charger pigtail MSI PN 503490-0001 DCE, 503489-
0002 DTE
Note
Allows serial output while being powered with Charger.
• Serial I/O cable (RS-232), 4m TPU Jacket, un-terminated. MSI PN 14359
• 26’ (8m) Hardwired cable for RF free Remote Display. Connects 8000 to 7300 Dyna-
Link. MSI PN 14052
• RF Remote Modem, RS-232, PN 14401, for direct connection to Computers,
Scoreboards, or serial printers.
• RF Remote Modem, RS-485, PN 14402, for direct connection to 485 Serial Devices.
• RF Remote Modem, USB, PN 14403, for direct connection to Computers USB ports.
• RF Remote Gateway for direct connection to an Ethernet LAN, PN 14404. For use
with MSI’s SCCMP program.
• RF or Hardwired Scoreboard Display. Various digit sizes from 1.2” to 8”. Contact
MSI for models available.
1.9 Unpacking
When unpacking the MSI-8000, ensure that all parts are accounted for. Check the MSI-
8000 for any visible damage and immediately report any damage to your shipper. It is
advisable to use the original shipping container when shipping or transporting the 
MSI-8000. A standard MSI-8000 is shipped with a battery charger. The charger is
universal and will work on AC supplies from 100VAC to 240VAC.